Construction Site Security
Construction Site Security in New York City
Licensed construction security guards for high-rise projects, renovations, demolitions and stalled sites across the five boroughs, with FDNY-certified fire guards available when a project calls for them.
Most New York City job sites have little room to spare. Materials sit on a narrow lot or several floors up, and trucks queue at the curb for the hoist. Tools, copper, fixtures and fuel end up spread across a site that is hard to see in one pass. McCray sets up construction site security in NYC as a defined post, with written orders tied to the project’s gates, delivery windows and work hours. For the service in other markets, see Construction Site Security.
Projects Covered in New York City
McCray provides construction security guards for:
- Ground-up high-rise construction
- Gut renovations and conversions
- Retail and office fit-outs
- Work inside occupied buildings
- Demolition and excavation
- Laydown and staging yards
- Paused or stalled projects
What Construction Site Security Covers
Gate and Access Control
Officers hold the main gate and any secondary entrances, confirm that each person entering appears on the contractor’s approved roster, sign in visitors and inspectors, and keep gates closed between movements.
Deliveries and Material Receiving
Officers log each truck against the delivery schedule, record what arrived and when, and alert the site contact when an unscheduled vehicle or an unexpected load shows up at the gate.
Equipment and Material Theft
Officers check gang boxes, tool cribs, fuel storage, copper and wire reels, and fixtures staged for installation, and report open containers, cut locks or missing stock as soon as they are found.
After-Hours and Weekend Patrol
When crews leave, officers walk the fence line, upper floors and laydown areas on a set route, check for trespass and damage, and record each round. Patrols can be fixed on site or run as mobile checks.
Renovations in Occupied Buildings
For work inside a tower, store or residence that stays open, officers keep trades on approved routes, control freight elevator and service entrance access, and separate the work zone from tenants and visitors.
Fire Watch
When a project needs a fire guard for torch work or an out-of-service fire protection system, McCray assigns officers who hold the applicable FDNY Certificate of Fitness. See Fire Watch in New York City.
Security Officers and Site Safety Are Separate Roles
The city states that every construction site needs a person certified by the Department of Buildings on site to supervise site safety. Depending on building height, that person is a Site Safety Manager, a Site Safety Coordinator or a Construction Superintendent. A site safety plan is required for new construction, enlargement, demolition and certain facade work on a major building, which includes a building of 10 or more stories or 125 feet or more in height, or one with a footprint of 100,000 square feet or more. The plan’s minimum content includes the construction fence and gates.
The Department of Buildings also requires fences where a new building is going up, a building is being demolished to grade or an excavation is open, and requires a chain link fence to secure a site where work has been interrupted or abandoned.
A security officer does not fill any of these roles. Officers do not supervise site safety, inspect work, sign safety logs, direct trades or decide whether a site complies with the Building Code. Their job is to control who and what comes through the fence, watch the site when no one else is there, and report what they see. Post Orders name the site safety professional or superintendent who receives reports of open gates, damaged fencing or unsafe conditions at the perimeter.
FDNY Fire Guards on Construction Sites
The FDNY issues Certificates of Fitness for specific fire safety duties. Two apply most often to construction.
Torch operations (F-60). The FDNY states that the fire watch for torch operations at construction sites must be conducted by F-60 fire guards, and lists the F-60 with its Hot Work Operations Permit. The FDNY’s F-60 study material states that the fire watch must continue for at least 30 minutes after hot work ends and that the persons conducting it must not have other duties.
Impaired fire protection systems (F-01). The FDNY’s F-01 page calls for a fire watch by Certificate of Fitness holders whenever a required fire protection system is out of service. An exception covers the first four hours of an outage affecting no more than 50,000 square feet, when the impairment coordinator or a trained and knowledgeable person designated by the owner may do the work. Once those four hours pass, only certified fire guards may patrol. The F-01 study material requires a check of the entire building at least once every hour, and notes that an F-60 watchperson on site does not satisfy this fire watch requirement.
Places of assembly (F-03 and F-04). The FDNY requires the F-03 for individuals assisting in maintaining fire safety at an approved place of assembly or temporary place of assembly at a specific location, and the F-04 for temporary place of assembly events at different locations. These relate to gatherings, not daily construction work.
Because a fire guard may not take on other duties, a gate officer and a fire guard are planned as separate posts. The FDNY rules, the permit holder and the impairment coordinator determine when a fire watch is needed and when it may end. The security provider staffs the watch but does not make that call.
Planning a Construction Security Post
Each site receives Post Orders covering gate locations, work hours, the approved roster and delivery schedule, areas where equipment and materials are staged, the contacts for the general contractor and site safety professional, and emergency steps. Coverage is scheduled around the hours when a site is most exposed and adjusted as the project moves from excavation to enclosure to fit-out. Officer levels follow the Officer Classification Program. For camera coverage of a fenced site, see remote video monitoring, and for paused projects, see vacant property security.
Officers are not police. An officer who finds a trespasser after hours watches from a safe position, calls 911 and the site contact, and writes up the event for the contractor’s records. Physical intervention is limited to what the law and the Post Orders allow.
Screening, Training and Supervision
Officers complete a five-stage screening process and tier-based training before assignment, including de-escalation and, for retail posts, organized retail crime recognition. Supervisors make unannounced site visits, and the McCray Operations Desk answers 24/7/365. Incidents are documented on scene, time-stamped and GPS-verified.
New York Licensing
New York security guard companies are licensed by the New York Department of State. Officers must complete Division of Criminal Justice Services approved training, including the 8-hour pre-assignment course, the 16-hour on-the-job course and 8 hours of annual in-service training. McCray Global Protection holds New York license 11000119645.
Common Questions
Do Construction Sites in New York City Need Security Guards?
The Department of Buildings requires a certified person to supervise site safety and requires fences at many sites, but those rules do not make a security officer a substitute for either. Adding security officers is usually a decision for the owner and general contractor, based on the value of what is stored on site, the hours the site sits empty and any contract or insurance terms.
What Is the Difference Between a Site Safety Manager and a Security Guard?
A Site Safety Manager is certified by the Department of Buildings to supervise site safety on larger projects. A security guard is registered with the New York Department of State, Division of Licensing Services, completes state-approved security guard training and protects the site from theft and trespass. Each role has its own requirements, and filling one does not satisfy the other.
Can the Gate Officer Also Serve as the Fire Guard?
Is a Fire Watch Required Before the Sprinkler System Is Installed?
The FDNY’s F-01 study material states that no impairment coordinator or fire watch is required before the system is installed and approved, which means every required approval, including Department of Buildings signoffs, has been obtained. The same material allows for exceptions where special circumstances require a fire watch. Torch work on a construction site still requires a fire watch by an F-60 fire guard.
Can Coverage Be Limited to Nights and Weekends?
Yes. Night and weekend posts are common, since that is when a site sits empty. Short-term posts can also cover a large delivery, a gap between trades or a pause in work.
How Is Construction Site Security Priced?
Rates depend on the officer classification, the number of posts, the hours and the site’s requirements. McCray provides a written rate schedule after reviewing the project. Holiday, overnight and short-notice coverage is billed at a premium rate.
Request Construction Site Security in New York City
Call (833) 832-6647 or request an assessment online. McCray provides all types of security services. Related pages: Construction Site Security, Construction and Development, Fire Watch in New York City, Security Guard Services in New York City.